Product Description
2003-2018 DODGE ALUMINUM CONVERSION DRIVE SHAFT
This a brand new Aluminum Drive shaft. This will fit 2003 to 2018 2500 / 3500 4x4 model trucks. (must have slip yoke at transfer case)
This shaft comes complete and ready to install (has the flange at the differential side)
please note this a 1480/1485 series drive shaft most 2014 and up trucks came with 1550/1555 series joints - the difference is the wider cross the cap size is the same - most ratings are done with 1480/1485 series joints
1550/1555 series parts are not readily available as 1480/1485 series are more common.
These 1480/1485 shafts are built strong and made to last
we do offer a steel 2 piece drive shaft with upgraded carrier bearing design if wanted
2003-2013 DODGE RAM 2500/3500 4X4 REAR DRIVE SHAFT UPGRADED 2 Piece Steel
Please CONFIRM before ordering your shaft's measurements from the SEAL of the transfer case to the flat face of the flange at the differential (see picture). Measuring off the truck this way allows the measurement to be more exact and take any lifts or changes to the drivetrain into account.
**PLEASE NOTE, YOU DO NOT NEED THE DRIVESHAFT INSTALLED IN THE VEHICLE TO MEASURE THIS WAY. IT WILL NOT MATTER WHETHER IT IS INSTALLED OR NOT, AS THIS MEASUREMENT IS OVERALL BASED ON THE TRUCK AND DOES NOT INVOLVE DRIVESHAFT
Features:
- Heavy Duty 5" .125 wall Alco Aluminum Tubing
- Upgraded 1480/1485 High Quality U-Joints
- New Flange Yoke Installed
- New Slip Yoke installed
- Fully Balanced
- Ready to install
This is NOT a original thin wall aluminum drive shaft- This is a custom made High Quality Drive shaft built to handle torque and power
**Please be advised anything over 86" S-F is subject to an oversize charge of $80 strictly for shipping
If you have any questions, please call! 661-633-2303